Description
Dimensions: 8′ W x 30′ L enclosed kitchen food trailer with a double 16,000 lb straight axle (+4.5′ tongue).
Tires and Safety: E-Rated (10-Ply) trailer tires, safety chains, electric brakes, and a breakaway kit per DOT regulations.
Interior Features: Stainless steel counters, cabinets, and shelves with aluminum supports.
Lighting: Equipped with (3) 4′ LED fixtures.
Electrical Panel: 125 Amp, 12-Space, two 4-Circuit Type-BR Outdoor Main Lug Sub Feed Panel with a 50 Amp/240 Volt power inlet.
Water System: 80-gallon fresh water tank, 135-gallon grey water tank, on-demand water pump with accumulator, fresh water inlet, and a direct water inlet in a lockable box that bypasses the freshwater tank.
Sanitation: NSF-approved handwashing sink with soap and paper towel dispensers.
Entrance: 36″” W x 72″” H (rough opening) main entrance door.
Comprehensive Trailer Plan
Structural Features
Subframe: 3″” I-Beam cross members on 12″” centers with a 4″” long rail. Mylar tape is applied between all-steel subframe components and extruded aluminum lower bottom rails to prevent corrosion.
Flooring: 1-⅛”” laminated hardwood floorboards, fastened to the subframe with two countersunk screws per board at each cross member in a staggered pattern. Floorboards are ship-lapped and pre-undercoated for protection from the elements, covered with .063 aluminum tread plate, and include a welded seam with a 6″” base and ⅜”” radius coving.
Side Skins: .040 aluminum panels, secured with rivets.
Side Wall Structure: Extruded aluminum top and bottom rails with 1-⅜”” deep galvanized steel z-shaped vertical posts on 16″” centers.
Front End: Aerodynamic aluminum radius with steel z posts and .040 aluminum panels, secured with rivets.
Roof: .032 one-piece aluminum sheet with anti-snag roof bows on 24″” centers and a crowned roof design to prevent water and ice pooling, featuring an aerodynamic aluminum radius and poly-tuff corner caps.
Exterior Lighting: Tecniq S34 LED clearance lights per FMVSS-108, installed on front corner caps, side top rails, and across the rear header. Includes LED turn signals and LED license plate lights.
Interior Walls: ⅝”” plywood attached to galvanized steel z-shaped vertical posts with 1″” foam insulation between posts on front and sidewalls, with a triple layer of ⅝”” plywood on the back wall. Finished with .24 quilted stainless steel sheets adhered to the plywood walls.
Ceiling: Insulated with 1″” foam and finished with .24 quilted stainless steel sheets, attached to framing on 24″” centers.
